I've only been able to get the LCD to display something once.
#1
I'm tearing my hair out over this one.. I ordered the freeplay CM3 and put it all together last night. Everything's hooked up properly, the correct image is flashed, and I can't get the device to show anything on the LCD. I took everything out of the case, made sure the ribbon cable was seated properly and powered up, still no display (just white light). I pulled the cable and re-seated it again. still nothing. I tried different battery combo's and actually got it to boot with one battery hooked up and the USB plugged in. Before I put it all back together, I plugged in both batteries and tested it again, it booted fine. Now that it's all back together, I can't get it to boot again. I did notice some strange clipping on the display for a few seconds when it was all out of the case and powered up.

What would you recommend at this point?

Thanks,

Mark
Reply


Messages In This Thread
I've only been able to get the LCD to display something once. - by dolesh84 - 02-06-2018, 08:15 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)