02-20-2017, 02:26 PM
(02-20-2017, 02:23 PM)Flavor Wrote:(02-20-2017, 02:17 PM)JerryFromFL Wrote:(02-20-2017, 02:15 PM)Flavor Wrote: No it's like 30 seconds. Does the green light come on?
This would be the green light would normally be just above where the X and Y buttons would be? If so, then no, that light does not come on.
Yeah, I'm talking about the LED above the X/Y buttons.
If you watch this video, you'll see how the bootup should look.
https://www.youtube.com/watch?v=ev4t_5DWbJo
If that LED isn't coming on, then there's something wrong between the GPA and the Raspberry Pi, because the green light is a signal from the Raspberry Pi. It basically means that the Raspberry Pi has taken control of the power (On/Off).
If the Raspberry Pi is installed/soldered upside down, it may exhibit this behavior. Otherwise, I'd guess maybe a faulty solder joint (or broken pin) between the Pi and GPA.
This is where photos would really help.
Understood. I have attached a photo and it shows how I've also covered the Pi GPIO pins so that they don't contact anything else.