01-27-2018, 06:28 AM
(This post was last modified: 01-27-2018, 06:34 AM by deliveryninja.)
Okay when I put it together, I placed a small piece of cardboard under the switch and it's raised it enough that it seems to work no problem.
The bottom right screw is just there to see how close I can get the board to the shell, I have been putting that in from the outside of the shell when testing.
Thanks for the help, I think it's all in place time for the final build!
The bottom right screw is just there to see how close I can get the board to the shell, I have been putting that in from the outside of the shell when testing.
Thanks for the help, I think it's all in place time for the final build!