I've got plenty of other questions about this:
* How long does a typical charge cycle for a 1000maH battery last?
** What is the charge current/voltage going through the board to the battery ports?
*** If it takes significantly longer, might the batteries be faulty?
*** Does that simply double with two batteries or is it split between ports?
*** How do I even tell that my battery cells are charging?
* What is the recommended current/voltage supplied by the power supply/charger to reach ideal results?
I am currently powering the board with two batteries connected from a phone charger with 5,2V / 2A output. No idea what is actually being put throug or what I would need.
You must have some recommendations or experiences of what type of charger (voltage/current) works fine with the board.
I would also love to have some way to verify that the batteries I have are just not duds and I need to get new ones. I was on that wild goose chase because of the two back LEDs lighting at once so I thought they at least charged but now I've had both of them hooked up and I still don't see a green light. Is there anything you can share about how to measure if a LiPo cell is actually dead?
* How long does a typical charge cycle for a 1000maH battery last?
** What is the charge current/voltage going through the board to the battery ports?
*** If it takes significantly longer, might the batteries be faulty?
*** Does that simply double with two batteries or is it split between ports?
*** How do I even tell that my battery cells are charging?
* What is the recommended current/voltage supplied by the power supply/charger to reach ideal results?
I am currently powering the board with two batteries connected from a phone charger with 5,2V / 2A output. No idea what is actually being put throug or what I would need.
You must have some recommendations or experiences of what type of charger (voltage/current) works fine with the board.
I would also love to have some way to verify that the batteries I have are just not duds and I need to get new ones. I was on that wild goose chase because of the two back LEDs lighting at once so I thought they at least charged but now I've had both of them hooked up and I still don't see a green light. Is there anything you can share about how to measure if a LiPo cell is actually dead?