Zero/CM3 Networking question [Solved]
#1
Apologies if this has already been asked but I haven't been able to find it via the forum Search option.  I have my Freeplay Zero and Freeplay CM3 both connected to wifi, FPZ is running a Pi0 W and my CM3 SD card was sitting in a Pi 3B so I could do some setup and config work while making case mods and doing test fittings.  My question is I can see both picking up an IP from my wifi but I am unable to connect to \\RETROPIE or to \\<IP ADDRESS>  like i can with a normal RetroPie install.  

Do the pre-built images change the base name to something else, is there some way to enable this functionality so i can get to my units over the network?

Thanks!
Reply


Messages In This Thread
Zero/CM3 Networking question [Solved] - by MrErickson - 11-01-2018, 09:45 AM
RE: Zero/CM3 Networking question - by Flavor - 11-01-2018, 10:18 AM
RE: Zero/CM3 Networking question - by MrErickson - 11-01-2018, 11:10 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)