Case fitting issues
#1
I recently got a Freeplay CM3 and I have been spending the last couple of nights trimming down plastic following the guide and some YouTube videos.  I feel pretty confident that I got everything possible but the board just doesn't seem to want to fit into the front of the case.  It fits good in the back of the case.  On the front of the case, the d-pad side fits down to the screw holes but the a-b button side is not sitting flush to be able to screw it down.  I don't see any rubbing plastic or any solder getting in the way.  

I attached some pictures and would love some advice on what I might have missed or where others might have run into similar issues.  This is my first time ever touching a Dremel too, so I am definitely going to have to try to fix it up a bit.


Attached Files Thumbnail(s)
                                               
Reply


Messages In This Thread
Case fitting issues - by jaycristo80 - 01-11-2019, 11:56 AM
RE: Case fitting issues - by Flavor - 01-12-2019, 04:57 AM
RE: Case fitting issues - by jaycristo80 - 01-12-2019, 05:14 AM
RE: Case fitting issues - by Flavor - 01-12-2019, 05:50 AM
RE: Case fitting issues - by jaycristo80 - 01-12-2019, 06:29 AM
RE: Case fitting issues - by jaycristo80 - 01-12-2019, 03:51 PM
RE: Case fitting issues - by Porcinus - 01-12-2019, 07:45 PM
RE: Case fitting issues - by Flavor - 01-14-2019, 01:41 AM
RE: Case fitting issues - by jaycristo80 - 01-14-2019, 02:52 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)