03-14-2019, 01:16 PM
Awesome as every time 
Did you make videos during the build process? I am really curious to see how you switched the left analog and dpad position
I made many 3D printing in the past, when I had to paint surface repaired with mastic or similar filler, the only solution I found was to use filler primer paint, sand, primer, put some layers of paint and then mat varnish (this part could look simple but is really critical) to get a smooth feeling. The only real way is to try, fail and retry but when you are going to master the technique, you will get gorgeous result
Did you make videos during the build process? I am really curious to see how you switched the left analog and dpad position
I made many 3D printing in the past, when I had to paint surface repaired with mastic or similar filler, the only solution I found was to use filler primer paint, sand, primer, put some layers of paint and then mat varnish (this part could look simple but is really critical) to get a smooth feeling. The only real way is to try, fail and retry but when you are going to master the technique, you will get gorgeous result