CM3+ Slim with Joy Con Analogs (Xbox layout)
#4
(03-14-2019, 01:16 PM)Porcinus Wrote: Awesome as every time Wink
Did you make videos during the build process? I am really curious to see how you switched the left analog and dpad position Smile

I made many 3D printing in the past, when I had to paint surface repaired with mastic or similar filler, the only solution I found was to use filler primer paint, sand, primer, put some layers of paint and then mat varnish (this part could look simple but is really critical) to get a smooth feeling. The only real way is to try, fail and retry but when you are going to master the technique, you will get gorgeous result Wink

I didn’t make any videos of the build process for this one, but I think it will easy to see everything in the next video when I take it apart to show. I’ll try to make sure to show everything well.
Reply


Messages In This Thread
RE: CM3+ Slim with Joy Con Analogs (Xbox layout) - by Hipcat - 03-14-2019, 02:41 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)