For cold molding, most of the time you can identify this when you see "waves" on flat surface.
For "not re-polished mold", injection mold wear with time, on the style of part, they usually correct defect with a Dremel, in my case they missed to re-polish the mold after :/
You shell look really clear, can you give me a link please
I am curious to know how you will clean the shell, on my side I have thinked about sand blasting for one time but the result will be horrible :/
On my side, I am working on the front shell, I had to fill Dpad, Start/Select and A/B button holes, I want to move Dpad on the bottom and have a similar ABXY buttons position as the SNES controller but more tilted.
I will send you picture of my current progress tomorrow via email
For the 3DS caps, I think I only found the same links as you. I know there are clear PSP 1000 stick cap, theses look similar to 2DS/3DS cap.
For "not re-polished mold", injection mold wear with time, on the style of part, they usually correct defect with a Dremel, in my case they missed to re-polish the mold after :/
You shell look really clear, can you give me a link please
I am curious to know how you will clean the shell, on my side I have thinked about sand blasting for one time but the result will be horrible :/
On my side, I am working on the front shell, I had to fill Dpad, Start/Select and A/B button holes, I want to move Dpad on the bottom and have a similar ABXY buttons position as the SNES controller but more tilted.
I will send you picture of my current progress tomorrow via email
For the 3DS caps, I think I only found the same links as you. I know there are clear PSP 1000 stick cap, theses look similar to 2DS/3DS cap.