Raspberry Pi 3 A+ crammed into a Freeplay zero!
    I had been wanting to make some sort of hand held project for a while but wasn't sure what to do... I happened across some of the older Freeplay zero kits on sale and snapped one up. I was also able to get a Raspberry Pi 3 A+ on sale which was just sitting around after an aborted smart mirror project. So decided to try and see if I could make it fit in the Freeplay zero kit...and it...sort of does? It definitely plays everything I've thrown at it, which is pretty much the same as the RPi 3 B+. I was able to use the retropie image that Freeplay provides for the CM3 and it works just fine.

Special thanks to Ed and Andrew for getting me fixed up for a small fee after I accidentally damaged my PCB (not because of the RPi 3 A+). Other than the fact that it sticks out rather awkwardly, it works and feels great. Cool

Attached Files Thumbnail(s)

Messages In This Thread
Raspberry Pi 3 A+ crammed into a Freeplay zero! - by TexasPorcupine - 03-24-2019, 12:53 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)