Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
FP Zero won't turn on when screwed close
#4
For example on the build I just finished, I was widening the port for the sound potentiometer wheel and it kept binding when tightened. Eventually I discovered that it was actually getting hung up on the shell's screw post further in back. I shaved off segments from about 40 degrees of the post and it spins freely now. It was an issue that the 2018 board I have on hand didn't have. Everything is idiosyncratic and each fit is ultimately a special snowflake, no matter how thorough the Freetech documentation is. It's just how it is when one is not using fabbing equipment with QC engineering processes.
Reply


Messages In This Thread
RE: FP Zero won't turn on when screwed close - by Bedwyr - 04-09-2019, 03:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)