06-04-2019, 07:29 AM
(This post was last modified: 06-11-2019, 08:34 AM by GameBro Advance.)
My Boxy Pixel shell should be arriving soon. I think that I’m going to use a combination of foam padding between the PCB and LCD, and a strip of Kapton tape going around the back of the LCD to keep it tight. I’ll let you guys know what my results are.
Update: It was a very tight fit. I had to use a knife to shave away the white plastic corners on the LCD in order to get the screen in. I didn’t use any foam, but I did use a bit of Kapton tape to hold the screen in place, although I don’t think it will be necessary.
Update: It was a very tight fit. I had to use a knife to shave away the white plastic corners on the LCD in order to get the screen in. I didn’t use any foam, but I did use a bit of Kapton tape to hold the screen in place, although I don’t think it will be necessary.