07-22-2019, 04:55 PM
Hello,
Your wiring is correct, please note that you can use GPIO40-43 but also pads under the Compute Module (35-39 I think).
GPIO 44-45 are used for I2C1.
You will just need to edit the driver config file to add the new inputs : /etc/modprobe.d/mk_arcade_joystick.conf
The pullup registers are set by the driver when it start.
Your wiring is correct, please note that you can use GPIO40-43 but also pads under the Compute Module (35-39 I think).
GPIO 44-45 are used for I2C1.
You will just need to edit the driver config file to add the new inputs : /etc/modprobe.d/mk_arcade_joystick.conf
The pullup registers are set by the driver when it start.