How to work with SD card partition?
#38
(11-05-2019, 08:02 AM)Flavor Wrote: If it turns on when you boot up, that's likely a problem.  

Did you do this part?
Code:
wget https://raw.githubusercontent.com/raspberrypi/linux/rpi-4.19.y/arch/arm/boot/dts/overlays/gpio-fan-overlay.dts
sudo dtc -W no-unit_address_vs_reg -@ -I dts -O dtb -o /boot/overlays/gpio-fan.dtbo gpio-fan-overlay.dts

Yeah, that's the first thing that I did. I'm not sure that it's turning on when it boots up, that could just be a clicking sound made by something else. Hard to tell if the fan is going or not.
Reply


Messages In This Thread
RE: How to work with SD card partition? - by Happyhaha2000 - 11-05-2019, 08:08 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)