11-26-2019, 01:14 AM
(This post was last modified: 11-26-2019, 01:16 AM by farlsmagee.)
ran jstest and here is what i get
it looks like the right stick Y axis just registers a constant value of -32000. If I pull the stick down, it is slow to register but eventually goes to +32000. bad solder job or bad stick?
another question... what are the four parameters for the x and y values? all mine are set like the following
y1params=550,3600,16,300
my left stick Y axis seems to have a little drift. if i push up on the stick, it comes back to rest at about -5000. If I bump the stick i can get it back to 0. If I push down on the stick, it bounces right back to 0. is this bad soldering? Can I overcome this problem by configuring the deadzone to be larger?
it looks like the right stick Y axis just registers a constant value of -32000. If I pull the stick down, it is slow to register but eventually goes to +32000. bad solder job or bad stick?
another question... what are the four parameters for the x and y values? all mine are set like the following
y1params=550,3600,16,300
my left stick Y axis seems to have a little drift. if i push up on the stick, it comes back to rest at about -5000. If I bump the stick i can get it back to 0. If I push down on the stick, it bounces right back to 0. is this bad soldering? Can I overcome this problem by configuring the deadzone to be larger?