eduke32 not launching

[TexasPorcupine]

Hi!

I can't seem to figure out why the eduke32 port won't launch for my Frankenpi (RPi 3 A+ in a Freeplay Zero Kit) I can get prboom (Doom) and wolf4sdl (Wolfenstein 3D) to work fine. When I try to get it to launch it just goes back to the "Ports" screen. Has anyone encountered this problem and found a solution? I am also running an old image because that is the only one that will boot in my A+ (18111301) if that makes a difference. I have read the "official" guide and it just says "the eduke32 port from the raspi-config repo should work."

Thanks in advance!