01-26-2021, 08:26 AM
Hey SuperGilfer!
The Freeplay Zero doesn't have extra GPIO pins necessary for the L2/R2 addon. The addon board also has solder spots that only match up with the Freeplay CM3 circuit board. The Freeplay Zero was never meant for expansion, since the pins are all used up already.
Having said that, there are 2 pins that you could try using, if you wanted to. They are pins 27 and 28 on the Pi Zero's pin header. We don't touch these, as they are typically used for Pi hat identification, but we do not ID our board using that method. I believe that there may be a way that you can put them in a GPIO mode and then could use them as button inputs by editing the /etc/modprobe.d/mk_arcade_joystick.conf file.
Check at https://cdn.sparkfun.com/assets/learn_tu...Zerov2.pdf (and the note of "GPIO 0 and 1 are reserved - Do Not Connect")
The Freeplay Zero doesn't have extra GPIO pins necessary for the L2/R2 addon. The addon board also has solder spots that only match up with the Freeplay CM3 circuit board. The Freeplay Zero was never meant for expansion, since the pins are all used up already.
Having said that, there are 2 pins that you could try using, if you wanted to. They are pins 27 and 28 on the Pi Zero's pin header. We don't touch these, as they are typically used for Pi hat identification, but we do not ID our board using that method. I believe that there may be a way that you can put them in a GPIO mode and then could use them as button inputs by editing the /etc/modprobe.d/mk_arcade_joystick.conf file.
Check at https://cdn.sparkfun.com/assets/learn_tu...Zerov2.pdf (and the note of "GPIO 0 and 1 are reserved - Do Not Connect")
Card Fighters' Clash 2 English Translation ( http://cfc2english.blogspot.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )