Black/Red FPZ and 3D Printed Cartridge Blank
#6
Sorry I disappeared for a while guys. I've been very busy and I just recently got married. I will have an STL file for you guys soon. I had to edit the clips, they will look slightly different than the ones in the original pic.

(12-07-2017, 09:06 AM)phoenixcaptain Wrote: Agreed! I'm curious, how easy is it to remove externally, for access to the usb and HDMI if needed?
It's extremely easy. On the original design, I popped in the side with the bigger clip first, then rotated the other side down and it just snapped in. I then reverse the process with my fingernail by prying up the side with the smaller clip. It holds while still requiring very little force to remove again. The plastic its printed in just barely flexes enough.
Reply


Messages In This Thread
RE: Black/Red FPZ and 3D Printed Cartridge Blank - by CaptNumbNutz - 01-10-2018, 07:45 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)