Freeplaytech Forum › Freeplay Zero / Freeplay CM3 / Game Pie Advance › Freeplay Zero/CM3 (AKA GPA) Hardware v
I have to hold Power Switch

Linear Mode
I have to hold Power Switch
CameraGuyKurt Offline
Junior Member
**
Posts: 8
Threads: 0
Joined: Jun 2018
Reputation: 0
#16
06-11-2018, 10:11 AM
So I've tried to level out the Hammer Header, as seen below. No change in results.

[Image: 2018-06-10%2020.05.06.jpg]

I had access to soldering gear over the weekend, so I tried soldering a header on another PiZeroW. Sadly, no change in behaviour.

[Image: 2018-06-10%2019.59.20.jpg]

Still open to any suggestions.
Find
Reply


Messages In This Thread
I have to hold Power Switch - by TylerDurden622 - 12-29-2017, 02:40 PM
RE: I have to hold Power Switch - by Flavor - 12-29-2017, 02:47 PM
RE: I have to hold Power Switch - by Mootikins - 06-05-2018, 03:36 AM
RE: I have to hold Power Switch - by Flavor - 01-03-2018, 03:11 AM
RE: I have to hold Power Switch - by Mootikins - 06-07-2018, 02:06 AM
RE: I have to hold Power Switch - by Flavor - 06-07-2018, 02:47 AM
RE: I have to hold Power Switch - by Flavor - 06-09-2018, 01:48 AM
RE: I have to hold Power Switch - by Flavor - 06-09-2018, 06:28 AM
RE: I have to hold Power Switch - by Flavor - 06-09-2018, 08:00 AM
RE: I have to hold Power Switch - by CameraGuyKurt - 06-11-2018, 10:11 AM
RE: I have to hold Power Switch - by Flavor - 06-12-2018, 01:20 AM
RE: I have to hold Power Switch - by Flavor - 06-12-2018, 02:15 AM
RE: I have to hold Power Switch - by Flavor - 06-12-2018, 03:24 AM
RE: I have to hold Power Switch - by Flavor - 06-12-2018, 08:06 AM
RE: I have to hold Power Switch - by Flavor - 06-14-2018, 02:41 AM
RE: I have to hold Power Switch - by Flavor - 06-14-2018, 11:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)