01-27-2018, 06:03 AM
(This post was last modified: 01-27-2018, 06:04 AM by deliveryninja.)
I have tried to remove some foam from behind the screen to see if it was holding the board too high but I am not sure it is possible to get it to catch without putting pressure on top of the power connectors. I screwed the circuit board in and took some pictures to show how it cannot currently go any lower than it is.
https://imgur.com/a/lxuLa
I think I'll find a way to rectify it, I was thinking a small wire to bind them together rather than glue or somehow extending the prong up. Alternatively I could put pressure on the power connector from the back of the case.
https://imgur.com/a/lxuLa
I think I'll find a way to rectify it, I was thinking a small wire to bind them together rather than glue or somehow extending the prong up. Alternatively I could put pressure on the power connector from the back of the case.