09-08-2018, 07:05 AM
For whoever this might help, I was able to get the PSP analog stick wired and working, but I first had to edit the /etc/modprobe.d/mk_arcade_joystick.conf file to this:
options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,41,40
afterwards, just hitting start, and going through the normal retropie control config wizard did the trick.
It was much harder to get it to fit in the case than it was to wire it up and configure it.
What I ended up having to do was take out the screw post farthest to the left (when looking from behind) and the bottom portion of the D-Pad's wall. This was the sweet spot.
I plan on hot gluing the analog stick directly to the cm3 circuit board, so my next case won't be cut so experimentally. How did you secure yours Flavor?
options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,41,40
afterwards, just hitting start, and going through the normal retropie control config wizard did the trick.
It was much harder to get it to fit in the case than it was to wire it up and configure it.
What I ended up having to do was take out the screw post farthest to the left (when looking from behind) and the bottom portion of the D-Pad's wall. This was the sweet spot.
I plan on hot gluing the analog stick directly to the cm3 circuit board, so my next case won't be cut so experimentally. How did you secure yours Flavor?