l2/r2 analog stick board

[NickM]

Your /etc/modprobe.d/mk_arcade_joystick.conf file should look something like this.

Code:

options mk_arcade_joystick_rpi map=4 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,-1,-1,-1,-1 hkmode=2
#this next line is for use with 4 extra buttons (maybe L2,R2,C,Z)
#options mk_arcade_joystick_rpi map=4 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,41,40 hkmode=2
#this next line is for use with a single PSP1000 analog stick
#options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,-1,41
#this next line is for use with 2 PSP1000 analog sticks
#options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 x2addr=75 y2addr=79 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,-1,41

Make it look like this, and then reboot and run the CONFIGURE INPUT.

Code:

#options mk_arcade_joystick_rpi map=4 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,-1,-1,-1,-1 hkmode=2
#this next line is for use with 4 extra buttons (maybe L2,R2,C,Z)
options mk_arcade_joystick_rpi map=4 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,41,40 hkmode=2
#this next line is for use with a single PSP1000 analog stick
#options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,-1,41
#this next line is for use with 2 PSP1000 analog sticks
#options mk_arcade_joystick_rpi map=4 hkmode=2 i2cbus=1 x1addr=72 y1addr=77 x2addr=75 y2addr=79 gpio=4,17,6,5,19,26,16,24,23,18,15,14,-20,42,43,-1,41

That was it! Thanks a lot.