09-08-2018, 10:59 PM
(This post was last modified: 09-08-2018, 11:27 PM by resonator79.)
Just tried my FP CM3 that I got yesterday after it being stuck in customs hell.
The buttons aren't working.
I did all the troubleshooting advice that is stated, I reconnected the CM3 module several times, I cleaned the contacts. Tried the rubber pads as well as an electrical screwdriver to make contact. I even tried various SD cards and 2 different versions of the image file. Everything works with a USB keyboard.
I'm willing to try another CM3 board, but before I spend another 40€ on that, am I missing something here?
The buttons aren't working.
I did all the troubleshooting advice that is stated, I reconnected the CM3 module several times, I cleaned the contacts. Tried the rubber pads as well as an electrical screwdriver to make contact. I even tried various SD cards and 2 different versions of the image file. Everything works with a USB keyboard.
I'm willing to try another CM3 board, but before I spend another 40€ on that, am I missing something here?