11-01-2018, 09:45 AM
(This post was last modified: 11-01-2018, 11:27 AM by MrErickson.)
Apologies if this has already been asked but I haven't been able to find it via the forum Search option. I have my Freeplay Zero and Freeplay CM3 both connected to wifi, FPZ is running a Pi0 W and my CM3 SD card was sitting in a Pi 3B so I could do some setup and config work while making case mods and doing test fittings. My question is I can see both picking up an IP from my wifi but I am unable to connect to \\RETROPIE or to \\<IP ADDRESS> like i can with a normal RetroPie install.
Do the pre-built images change the base name to something else, is there some way to enable this functionality so i can get to my units over the network?
Thanks!
Do the pre-built images change the base name to something else, is there some way to enable this functionality so i can get to my units over the network?
Thanks!