Zero/CM3 Networking question [Solved]
#1
Apologies if this has already been asked but I haven't been able to find it via the forum Search option.  I have my Freeplay Zero and Freeplay CM3 both connected to wifi, FPZ is running a Pi0 W and my CM3 SD card was sitting in a Pi 3B so I could do some setup and config work while making case mods and doing test fittings.  My question is I can see both picking up an IP from my wifi but I am unable to connect to \\RETROPIE or to \\<IP ADDRESS>  like i can with a normal RetroPie install.  

Do the pre-built images change the base name to something else, is there some way to enable this functionality so i can get to my units over the network?

Thanks!
Reply
#2
I am out trick or treating at the moment. I can’t be too much help, but check here https://forum.freeplaytech.com/archive/i...-4509.html
Card Fighters' Clash 2 English Translation ( http://cfc2english.blogspot.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )
Reply
#3
(11-01-2018, 10:18 AM)Flavor Wrote: I am out trick or treating at the moment. I can’t be too much help, but check here https://forum.freeplaytech.com/archive/i...-4509.html

I will give that a shot. 

Thanks!!

::Edit::

Looks like that did the trick.

Thank you Sir!!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)