12-23-2018, 01:03 PM
(This post was last modified: 12-24-2018, 01:51 AM by SuperSirLink.)
Just got my FPZ this weekend and here is my build... I am working on mimicking an NES controller. Need to adjust the overscan settings to adjust for the expanded area. Great product, thanks Ed!
![[Image: NAZB8zGh.jpg]](https://i.imgur.com/NAZB8zGh.jpg)
I also made a few deviations to the screen placement in an attempt to use more of the screen and center it more... The edge of the screen by the Y button is blank plastic that can be cut away... You just have to be extremely cautions and deliberate with your cuts...
![[Image: yqwMkPBh.jpg]](https://i.imgur.com/yqwMkPBh.jpg)
The there is a gap now between the LCD and the other side wall, but this little corner will keep it in place...
![[Image: pzhwawzh.jpg]](https://i.imgur.com/pzhwawzh.jpg)
The shaded area is screen area that is now visible... I just have to get a clear glass to allow for the larger area...
![[Image: CB8llE1h.jpg]](https://i.imgur.com/CB8llE1h.jpg)
![[Image: INQ2Gm8h.jpg]](https://i.imgur.com/INQ2Gm8h.jpg)
Edit:
I realized that some of those photos were taken before I made my final cuts... This corner was actually trimmed further to allow the screen to sit straight. I also padded the corners with some foam to keep them held down against the front of the case...
The top corner by the shoulder button was thinned down, but not removed completely, the lower marked corner was removed along the line...
![[Image: nzrjeMCh.jpg]](https://i.imgur.com/nzrjeMCh.jpg)
I also made a few deviations to the screen placement in an attempt to use more of the screen and center it more... The edge of the screen by the Y button is blank plastic that can be cut away... You just have to be extremely cautions and deliberate with your cuts...
The there is a gap now between the LCD and the other side wall, but this little corner will keep it in place...
The shaded area is screen area that is now visible... I just have to get a clear glass to allow for the larger area...
Edit:
I realized that some of those photos were taken before I made my final cuts... This corner was actually trimmed further to allow the screen to sit straight. I also padded the corners with some foam to keep them held down against the front of the case...
The top corner by the shoulder button was thinned down, but not removed completely, the lower marked corner was removed along the line...