Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
CM3+ Slim with Joy Con Analogs (Xbox layout)
#31
Do you have a picture of the defects?

Based on defects I have seen on my side, I think there are 3 molds used the GBA shells:
- One have a defective extractor on the front shell, under the screen. On the back shell there is a unpolish part near one of the screw passage.
- Another one have a huge problem on the front shell near start/select.
- The last one have a miss alignment on the accessories parts.

I always buy shells from China, you can source each case for less than 7 USD shipped, the only problem is the time it take to arrive...
Reply
#32
(04-07-2019, 12:51 PM)Porcinus Wrote: Do you have a picture of the defects?

Based on defects I have seen on my side, I think there are 3 molds used the GBA shells:
- One have a defective extractor on the front shell, under the screen. On the back shell there is a unpolish part near one of the screw passage.
- Another one have a huge problem on the front shell near start/select.
- The last one have a miss alignment on the accessories parts.

I always buy shells from China, you can source each case for less than 7 USD shipped, the only problem is the time it take to arrive...


Attached Files Thumbnail(s)
               
Reply
#33
"Clear" case I have received have the same defects as picture 2 and 3.
I never had defects like picture 1 and 4.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)