Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
USB-C charging on a freeplay cm3 build?
#1
Did a search and nothing showed up. I’m just trying to get as much info as I can before I go ahead with my build. Have anyone modded the freeplay cm3 board to run off of usb-c instead of the micro usb? Is it as simple as removing the micro USB port and soldering in a usb-c port? Or do you need like extras like a resistor or capacitor? Electrical stuff is not my forte. I will assume usb-c will pull a lot more power if given and am wondering if the board on the freeplay cm3 can handle all of that or not. I know there are power restrictions on the micro USB port itself so I assume it is regulated for that?
Reply
#2
The Freeplay Zero and Freeplay CM3 are not set up to handle USB-C.

It's not as simple as replacing one port with the other. There is additional hardware that's required to interface with the USB-C power supply.

We have looked at some USB-C to MicroUSB adapters, but they don't even properly follow the spec sometimes, so we can't recommend using any particular one. You're right that USB-C can supply more power and it can supply different voltages. The hardware needs to be made specifically for USB-C to handle it properly.
Card Fighters' Clash 2 English Translation ( http://cfc2english.blogspot.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)