03-27-2020, 04:54 PM
You should use the multi-meter in resistance test mode (not sure of the English name), the highest value.
First, you will need to found what part of the pad is ground, it is common to other pads, you will need to use the other part for the continuity test.
If there is a continuity, you should read 0.
I have a picture of a old motherboard, for B, the part of the pad that interest you should the second or the last (a trace touch the B marking).
First, you will need to found what part of the pad is ground, it is common to other pads, you will need to use the other part for the continuity test.
If there is a continuity, you should read 0.
I have a picture of a old motherboard, for B, the part of the pad that interest you should the second or the last (a trace touch the B marking).