dual analog install errors
#2
update, got most features running, got the controller config file set correctly, still not getting the dual analogs to recognize in the controller config when i get into retropi
i decided to pull the back off while the system was on, and did a quick voltage check.

with the wifi dongle plugged in, i only read 1.3 something volts at the header that as i understand should be 5v.
the l2/r2 board is soldered through the holes from one side to the other, full pass-through. continuity tested 0 ohms. good connection.

anyone else experience this?
Reply


Messages In This Thread
dual analog install errors - by sips216 - 07-19-2020, 02:42 PM
RE: dual analog install errors - by sips216 - 07-20-2020, 11:49 AM
RE: dual analog install errors - by Flavor - 07-21-2020, 10:30 AM
RE: dual analog install errors - by sips216 - 07-22-2020, 01:51 AM
RE: dual analog install errors - by Flavor - 07-22-2020, 02:12 AM
RE: dual analog install errors - by sips216 - 07-22-2020, 12:56 PM
RE: dual analog install errors - by a-butta - 07-23-2020, 04:50 AM
RE: dual analog install errors - by sips216 - 07-23-2020, 04:29 AM
RE: dual analog install errors - by sips216 - 07-23-2020, 08:39 AM
RE: dual analog install errors - by sips216 - 07-26-2020, 03:40 PM
RE: dual analog install errors - by Flavor - 07-28-2020, 03:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)