07-22-2020, 01:51 AM
hey, i sorted out the R button ordeal. i think something got funky with the configuration. i went through multiple retries of re-adapting the configs for the buttons, so i think that was what messed up there.
as for the voltage probe, i checked at the two solder-through connecton points right where you indicated in your pic "GND"
it was reading 1.3 where the power should be 5v, if i understnad correctly. that's what the front side of the mobo indicates to be there.
i'll tear into it later this afternoon after i'm off work. i'll do like you suggested and remove the analog sticks. i'm suspect as they came from amazon, so we'll see what happens there. my soldering for the most part has been very clean. i am using a liquid flux, which should isolate the solder a bit more carefully, and help seal things a tad when dried.
as for the voltage probe, i checked at the two solder-through connecton points right where you indicated in your pic "GND"
it was reading 1.3 where the power should be 5v, if i understnad correctly. that's what the front side of the mobo indicates to be there.
i'll tear into it later this afternoon after i'm off work. i'll do like you suggested and remove the analog sticks. i'm suspect as they came from amazon, so we'll see what happens there. my soldering for the most part has been very clean. i am using a liquid flux, which should isolate the solder a bit more carefully, and help seal things a tad when dried.