01-04-2022, 07:05 AM
Just a warning, I am new to using retropie and to the forum. Sorry in advance if this issue has already been posted and resolved.
I recently assembled a CM3 with the L2R2 dual analog 4ADC add-on board. Everything went smooth until I got to the end and startedĀ setting up the software. I set up SSH and Putty on my computer to type in the necessary commands that were listed towards the end of the document linked below. I ran into fatal errors over and over again after typing the commands as shown. I'm using the most current CM3 image (Freeplay_CM3_20051201img.gz). Does anyone have any suggestions? I'd really appreciate the help.
https://docs.google.com/document/d/13ztk...tT_ok/edit
I recently assembled a CM3 with the L2R2 dual analog 4ADC add-on board. Everything went smooth until I got to the end and startedĀ setting up the software. I set up SSH and Putty on my computer to type in the necessary commands that were listed towards the end of the document linked below. I ran into fatal errors over and over again after typing the commands as shown. I'm using the most current CM3 image (Freeplay_CM3_20051201img.gz). Does anyone have any suggestions? I'd really appreciate the help.
https://docs.google.com/document/d/13ztk...tT_ok/edit