07-18-2022, 06:24 AM
Here's an update on the case:
I had to trim a lot on the back to let the CM4 come out of the case. This board's dimensions allow for a little bit of the top screw posts to still hold the screws even if almost half of them needs to be shaved off. I broke one of them when using the dremel tool but nothing too bad that a little bit epoxy can't fix
The board has a reset button on the left side, which can be accessible and still have enough room for the screw to keep the whole thing together.
A little bit of the cartridge slot had to be shaven off too, to give the board more room to come out of the case
I had to trim a lot on the back to let the CM4 come out of the case. This board's dimensions allow for a little bit of the top screw posts to still hold the screws even if almost half of them needs to be shaved off. I broke one of them when using the dremel tool but nothing too bad that a little bit epoxy can't fix

The board has a reset button on the left side, which can be accessible and still have enough room for the screw to keep the whole thing together.
A little bit of the cartridge slot had to be shaven off too, to give the board more room to come out of the case