02-05-2017, 01:36 PM
Hi, I just got a GPA Model 2 kit, I soldered the the pins into the Pi zero and plugged and plugged the zero into the board.
2 things happen.
1 I need to hold down the power button for it to stay on
2 the display is white
I get signal from the pi when the HDMI is plugged in, the battery charges and and everything else looks looks to be fine.
Forgive me if there are any obvious glaring flaws or missteps. I have tried googling and searching for set up information regarding this but I have found little.
2 things happen.
1 I need to hold down the power button for it to stay on
2 the display is white
I get signal from the pi when the HDMI is plugged in, the battery charges and and everything else looks looks to be fine.
Forgive me if there are any obvious glaring flaws or missteps. I have tried googling and searching for set up information regarding this but I have found little.