Hmm so an interesting development. I took the thing apart and the LCD was already sitting flush to the top and centered (as far as I could tell) left and right. I put a piece of thin foam below the screen and the horizontal wall. The top and right border is still there. I am sure the top wall is correct (just like in the pictures). Since the borders are on the top and right (near the A/B buttons), I wonder if I need to remove more of the plastic around that area to let it shift over more. This is weird because if I remove too much, it will sit against the opposite wall (toward D-Pad) and can shift.
Does the FPZ image have overscan settings built in somewhere? I see the config.txt has the settings commented out (default). I tried adding negative top and right values but really can't tell if it's make a difference.
Update: I took it apart and reassembled it three more times trying to fix the problem. My piece of foam at the bottom seems to be helping since the top border is practically gone now. I still have the right one. Can I use overscan settings to fix this?
Does the FPZ image have overscan settings built in somewhere? I see the config.txt has the settings commented out (default). I tried adding negative top and right values but really can't tell if it's make a difference.
Update: I took it apart and reassembled it three more times trying to fix the problem. My piece of foam at the bottom seems to be helping since the top border is practically gone now. I still have the right one. Can I use overscan settings to fix this?