01-27-2018, 08:37 PM
(This post was last modified: 01-27-2018, 08:40 PM by deliveryninja.)
I have it up and working no problem with 1 battery. I've ordered 2 more actually as the black lead has disconnected from one of the batteries due to the force I needed to use to get the leads out when the build didn't work. I had actually shaved off the centre bar on the connectors but still required a lot of force. One issue is I hadn't opened up the battery pack enough to use the pliers to pull out the leads properly.
As for the power switch it seems to be behaving at the moment. I have just used the craft knife to cut small pieces of cardboard and place it under the switch to raise it.
SD Card is a strange one, not sure why it stopped working after doing a restart of the system from the retropi menu. Just a side note is to use windows disk management to remove all partitions before reformatting with the img using win32diskimager or it won't work. Using the power button to shutdown works fine.
As for the power switch it seems to be behaving at the moment. I have just used the craft knife to cut small pieces of cardboard and place it under the switch to raise it.
SD Card is a strange one, not sure why it stopped working after doing a restart of the system from the retropi menu. Just a side note is to use windows disk management to remove all partitions before reformatting with the img using win32diskimager or it won't work. Using the power button to shutdown works fine.