LCD off center

[Mootikins]

Unfortunately I forgot that I put some 3D printed caps on my XY and they make it impossible for me to remove the front, but I have highlighted the portion of the build doc that needs to be cut. If you decide to go the expanded display route, you will also need to cut some of that plastic housing on the LCD and some of the retaining wall on the bottom portion (I actually used the edge some to brace the display). If you do not, it will hit parts of the shell and the Y button post. The parts I am talking about are the large white blocks on each side of the ribbon cable and the thin bar across them. I recommend doing this with snips as a stray move with a dremel will damage the backlight diffuser and could cause bright spots.