Analogue stick without addon board

[DavidRaid]

Hi Porcinus!

Thanks for your reply!

If I were to buy this ADS1015 chip, what type of joystick would work with it? PSP 1000, Vita or Switch Joy-Con?

And, while I'm stealing your expertise... Where and how would I connect this chip to a joystick and to the freeplay board? Can it be used in conjunction with the boxypixel R2/L2 add on board?

I've seen that the psp 1000 stick has four pads to solder to, the two axis, ground and vcc, and that the vita stick can be converted to this from its ribbon cable using a 6-pin connector but I'm unsure on the specifics.

Thanks

I'm a total novice at working on electrical boards themselves and have stuck completely to all in one boards up to now. I've honestly only just learnt how to solder and I'm not even sure what type of wire to be soldering between these chips haha