07-12-2021, 02:31 AM
I already have a post open right now for the cm3 not wanting to fit with the pre-installed heat sink, but I have another issue and didn't want to post them in the same one in case one's an issue for someone else later.
I assume there's just a setting somewhere to turn it on or off, or maybe it's set to come on at a specific temp, I'm not sure. How would I go about getting it to work or verifying it's functioning correctly?
The solder is good and the wires don't get pinched when the shell is assembled.
I assume there's just a setting somewhere to turn it on or off, or maybe it's set to come on at a specific temp, I'm not sure. How would I go about getting it to work or verifying it's functioning correctly?
The solder is good and the wires don't get pinched when the shell is assembled.