07-28-2020, 01:39 PM
(07-28-2020, 03:01 AM)Flavor Wrote: Hey zawoogle,
I was out all weekend, so I'm sorry that I couldn't respond easily. What's the current status of this? Would you be able to post some photos of it? I'm not actually 100% sure I understand what went wrong. Did you install the board upside-down?
How are the analog sticks detected in SSH? What test are you doing, 'jstest'?
Hey no worries! I was talking about the small header pins that we are supposed to solder into the tiny holes on the motherboard where we then attach the L2R2 addon board for Boxypixel. I got past that part but now I can't figure out why my CM3 wont power on without a micro USB cable attached.
