12-25-2017, 09:25 AM
Wow, thanks for the very quick and detailed reply.
I actually just glued some plastic piece on the right "finger" of the switch. I hope this stays; There should not be any pressure on the sides of it so I guess it should stay where it is. This way the power switch works reliably. Thank you very much! Now I just have to work a few software issues out and then I'm good to go
Btw: I have 2 or 3 other sliders here as well, but they are just the same as mine. So, if you actually have some special sliders with wider/bigger fingers laying around, it would be cool if you could send me one in a letter or whatever, so I have some sturdy replacement if my glued part should fall off. Just hit me with a PM.
I actually just glued some plastic piece on the right "finger" of the switch. I hope this stays; There should not be any pressure on the sides of it so I guess it should stay where it is. This way the power switch works reliably. Thank you very much! Now I just have to work a few software issues out and then I'm good to go
Btw: I have 2 or 3 other sliders here as well, but they are just the same as mine. So, if you actually have some special sliders with wider/bigger fingers laying around, it would be cool if you could send me one in a letter or whatever, so I have some sturdy replacement if my glued part should fall off. Just hit me with a PM.