01-23-2019, 07:32 AM
(This post was last modified: 01-23-2019, 07:34 AM by mason.wm.richins@gmail.com.)
(01-08-2019, 04:14 AM)Flavor Wrote: The SD image files are named like
Freeplay_Zero_YYMMDDVV.img.gz and Freeplay_CM3_YYMMDDVV.img.gz
For you, grab the newest Freeplay Zero image (which is currently Freeplay_Zero_18091302.img.gz). If that doesn't work, for some reason, the previous one (Freeplay_Zero_18032101.img.gz) is there for you to try.
You should not have to edit anything. Use Etcher to burn the SD image to your SD card. Then, pop it into your Pi and boot it up. The first bootup will be odd, because it will start up and then shut itself down. Just boot it up a second time, and then it'll work properly. The first bootup resizes itself to use your entire SD card.
Hi, sorry for the late reply. I've been out of town. So I did originally burn the correct image and followed everything else correctly. I ended up buying another pi zero to see if that's the problem and unfortunately it isn't. The buttons ended up freezing again after a couple minutes of gameplay. What I did notice was that I think the gb seemed to function fine until I added them into the case and tightened the screws. I think it froze after I put on the front gb shell. I don't know if that's significant or not though. The internals do seem to be somewhat cramped but I didn't see any serious pressure points. Taking off the front shell after that didn't seem to fix the problem. At this point I have no idea what to do...