06-19-2026, 04:14 AM
(03-09-2026, 09:13 PM)Ahchay Wrote: I know this thread is a million years old, but do you still have access to that linker?
I've got a bunch of alix flash carts that my linker (the game-bank one) won't work with - was wondering if it would be possible to try them with the Sanni one - I get about 50% success rate with these but it would be nice to get that percentage up
I can send you a couple for testing
I'm not sure if I have it wired up on a breadboard anymore. It's not terribly complicated to set up if you want to try on your end if you have basic soldering tools. You cut a section out of a PCI slot to mate up with the cartridge. If you've got a linker that isn't working, you could likely wire directly into that.
The original experiment was a bust. It don't think the chip was receiving sufficient power to boot, let alone act as flash memory. I designed another board hoping to have data loaded onto RAM chips that the NGPC can interface with directly.