Freeplaytech Forum › Freeplay Zero / Freeplay CM3 / Game Pie Advance › Freeplay Zero/CM3 (AKA GPA) Hardware v
3D Print Battery Cover

Linear Mode
3D Print Battery Cover
HoraceAndTheSpider Offline
Junior Member
**
Posts: 23
Threads: 2
Joined: Feb 2018
Reputation: 0
#4
02-21-2018, 05:30 AM
Ok, so it looks like 5mm was a good estimate, for actual 'space' to be added. (i.e. going from the end of the existing space, to the top of the new battery depth) but 6mm, if possible, would probably be more accomodating.

https://drive.google.com/open?id=0B4272M...29EV0hkc0k
Find
Reply


Messages In This Thread
3D Print Battery Cover - by HoraceAndTheSpider - 02-18-2018, 08:55 PM
RE: 3D Print Battery Cover - by spideyk21 - 02-21-2018, 01:59 AM
RE: 3D Print Battery Cover - by HoraceAndTheSpider - 02-21-2018, 05:30 AM
RE: 3D Print Battery Cover - by Flavor - 02-21-2018, 06:36 AM
RE: 3D Print Battery Cover - by spideyk21 - 02-21-2018, 07:10 AM
RE: 3D Print Battery Cover - by spideyk21 - 02-22-2018, 06:49 AM
RE: 3D Print Battery Cover - by spideyk21 - 02-27-2018, 11:17 PM
RE: 3D Print Battery Cover - by Flavor - 02-27-2018, 11:55 PM
RE: 3D Print Battery Cover - by spideyk21 - 03-12-2018, 04:48 AM
RE: 3D Print Battery Cover - by spideyk21 - 03-28-2018, 04:36 AM
RE: 3D Print Battery Cover - by strongbad - 05-16-2018, 08:23 AM
RE: 3D Print Battery Cover - by spideyk21 - 05-17-2018, 01:57 AM
RE: 3D Print Battery Cover - by spideyk21 - 06-28-2018, 12:12 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)