09-13-2018, 12:03 PM
I did as you said, and exactly what you said is what happened when I plugged in the microusb- quick screen flash of white, then the red led came on instantly. Never turned off.
I can open the case tomorrow and post some photos. I didn’t solder the pi, I used the hammer header. The only soldering I did were the 2 wires for the brightness adjuster to the back of the pcb. I can take some photos of that, but they didn’t give me any trouble and the brightness adjuster has been functioning fine.
I’ve played the system until the light has turned red before many times, but never to the point where it shut itself off. And every time I’ve recharged it after that the red light has turned off.
I can open the case tomorrow and post some photos. I didn’t solder the pi, I used the hammer header. The only soldering I did were the 2 wires for the brightness adjuster to the back of the pcb. I can take some photos of that, but they didn’t give me any trouble and the brightness adjuster has been functioning fine.
I’ve played the system until the light has turned red before many times, but never to the point where it shut itself off. And every time I’ve recharged it after that the red light has turned off.