Brightness control and L2/R2 addon board

[stevo619]

You can have both, stevo619.  

This isn't a problem at all, but we should have been more aware that you ordered the L2/R2 add-on and then not soldered on the brightness controller before shipping.  They can both be soldered to the same points.

We should have left the brightness unsoldered, because then it's easier to solder in the pins for the L2/R2 board first and then add the brightness wires.  

You can just heat up those through-holes (44/45) and remove the wires.  Then solder in the pins for the add-on board.  Then, after you have the L2/R2 add-on all in place, you can just tack the wires onto the solder points.

Let us know how that goes.

I did solder the wires in and the brightness controller works flawlessly. I am chasing around a few other issues with the add on board still. 

Thank you so much for the quick response and knowledge on the subject.