07-27-2021, 01:52 AM
Hey, OnlyCatapults. Is this on a Freeplay CM3 or Zero?
You could try this.
Log in, and don't press any buttons. Run:
gpio readall
Then, while holding a X and A down, run it again:
gpio readall
Post the BEFORE and AFTER outputs, and we'll try to see if the button itself is actually working. Then, we can move on to the mk_arcade driver stuff and the make config.
You could try this.
Log in, and don't press any buttons. Run:
gpio readall
Then, while holding a X and A down, run it again:
gpio readall
Post the BEFORE and AFTER outputs, and we'll try to see if the button itself is actually working. Then, we can move on to the mk_arcade driver stuff and the make config.
Card Fighters' Clash 2 English Translation ( http://cfc2english.blogspot.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )
Neo Geo Pocket Flash Cart and Linker Project ( http://www.flashmasta.com/ )
Avatar art thanks to Trev-Mun ( http://trevmun.deviantart.com/ )