04-19-2022, 11:25 AM
Wasn't sure exactly which image you were referring to so I armed it on both and it didn't change either response. Cm3 4.6 says command not found and Cm3+Zero2 gives the same empty lines.
Interestingly, while in the retropie-setup menu I was constantly getting a left input cycling through the menu options on the CM3+Zero2 img but not on the Cm3 4.6 img. Could be an issue with one of the contacts there, so I will end up resoldering this thing later.
Interestingly, while in the retropie-setup menu I was constantly getting a left input cycling through the menu options on the CM3+Zero2 img but not on the Cm3 4.6 img. Could be an issue with one of the contacts there, so I will end up resoldering this thing later.